Liquid Controls XL LED Display E1615_E1616_E1617_E1618 - Manual (Page 6)

InstallatIon overvIeW & GuIdelInes
The LectroCount XL LED Remote Display and accessories (whether supplied by Liquid Controls or other) must
be installed and operated in accordance with all applicable federal, state, and local construction, electrical,
environmental and safety codes. Failure to do so could result in serious injury or death.
! WarnInG
Installation overview
The LectroCount XL LED Remote Display is shipped with a 30 foot, 4-wire, shielded cable threaded through a cord
grip at the bottom of the display housing and a selection of unit of display labels twist-tied to the display.
Installation overview for the LectroCount XL LED Remote Display:
1. Check contents of the shipment and ensure that the correct model is included. page 4
2. Determine which accessories and settings are required and incorporate them into installation. pages 13-17
3. Mount the LectroCount XL LED Remote Display. page 7
4. Wire the LectroCount XL LED Remote Display. pages 8-12
Installation Guidelines
• READ thIS mAnuAL PRIoR to StARt oF InStALLAtIon
If you have any questions, consult with your full service distributor or call the Service Department at Liquid Controls.
• AvoID EXCESSIvE vIbRAtIon oR ShoCk
Ensure that the display does not sustain any excessive vibration or shock. The display should always be securely mounted to a platform or
supportive member.
• mAtCh LECtRoCount XL LED REmotE DISPLAy wIth thE PRoPER DEvICE
The four models of the LectroCount XL LED Remote Display are designed for use with the devices specified No attempt should be made to
connect the display to an input other than the specified device. Model numbers and compatibility are specified on the display’s serial number
tag. page 4 Model Number and Device Compatibility
• uSE PRoPER CAbLInG AnD wIRES
The LectroCount XL LED Remote Display is supplied with a 30 foot 4-wire shielded cable with 22 gauge wire. The shielded cable should be
adequate for most installations. If alternate cabling is required, Liquid Controls recommends a 4-wire shielded cable with 22 gauge wire or larger
and a maximum cable length of 30 feet.
• SECuRE CAbLE AnD tIGhtEn CovER uPon REASSEmbLy
LectroCount XL LED Remote Displays are assembled and shipped ready for final cable termination. If the display’s preinstalled shielded
cable is removed during installation, be sure to secure the cable and tighten the cover screws in the correct torque pattern so the vapor seal is
maintained. page 18 Torque Specifications
6