Liquid Controls XL LED Display E1615_E1616_E1617_E1618 - Manual (Page 13)

autoMatIc shutoff - WIrInG
Automatic Shutoff wiring
The LectroCount XL LED Remote Display can be wired to turn on and shut off automatically. If wired for automatic
shutoff, the display will automatically turn on when a delivery is initiated. The display will remain lit until a delivery
ticket is printed. When the delivery ticket begins printing, the display will automatically shut off. Only models E1615
and E1616 can be wired for automatic shutoff.
to wire a LectroCount XL LED Remote Display for automatic shutoff:
1. Connect the power and two signal wires according to the instructions.
2. Instead of connecting the black (GND) wire to terminal 41 on the J12 terminal block,
connect the black (GND) wire to
terminal 44 of the J12 terminal block on the LectroCount register CPU board.
81547-2
CPU Board
Remote Display
PCB Board
GND/
Blac
k (41)
OUT 4/
Green
(40)
+V
o/
Re
d (45)
GND/
Blac
k (56)
A/
Green
(55)
B/
White
(54)
PWR/
Re
d (53)
Jumper
OUT 5/
White
(39)
Shieled cable
ground wire
grounded to
remote display
PCB board
840404, 84040,
or 81920 CPU Board
Remote Display
PCB Board
GND/
Blac
k (41)
OUT 4/
Green
(40)
+V
o/
Re
d (45)
GND/
Blac
k (56)
A/
Green
(55)
B/
White
(54)
PWR/
Re
d (53)
Jumper
OUT 5/
White
(39)
Shieled cable
ground wire
grounded to
remote display
PCB board
Model E1615 Automatic Shutoff Schematic Model E1616 Automatic Shutoff Schematic
13