Liquid Controls XL LED Display E1615_E1616_E1617_E1618 - Manual (Page 14)

wiring the Dual Display kit -
Pn 82594
The dual display kit allows two LectroCount XL LED Remote Displays to display the delivery volume of a single
LectroCount electronic register. This dual display kit includes:
• 4-port conduit box
• Cord grip (2)
• Nipple & seal washer
WIrInG - dual dIsPlay kIt
GND/
Blac
k (56)
A/
Green
(55)
B/
White
(54)
PWR/
Re
d (53)
Jumper
Shieled cable
ground wire
grounded to
remote display
PCB board
First Display Unit
Wires
Second Display Unit
Wires
Remote Display
- Second Unit -
LectroCount Register
82594 Kit
Remote Display PCB Board
- First Unit -
LectroCount XL LED Remote Displays are assembled and shipped ready for final cable termination.
If the display’s pre-installed shielded cable is removed during installation, be sure to secure the cable
and tighten the cover so the vapor seal is maintained. See page 18 for proper torque specifications.
Secure Cable and Tighten Cover Upon Reassembly
to install the Dual Display kit:
1. Remove the rear panel from one LectroCount XL LED Remote Display.
2. Remove the cable wires from the J1 terminal block on the PCB.
3. Remove the cord grip and cable from the port on the bottom of the unit.
4. Attach the 4-port conduit box to the empty port on the bottom of the unit.
5. Attach the cord grips to the 4-port conduit box.
5. Route the shielded cable from the second LectroCount XL LED Remote Display through one of the cord grips on the 4-port
conduit box.
6. Route the shielded cable from the first LectroCount XL LED Remote Display through the other cord grip on the 4-port conduit
box.
7. Connect the wires from both shielded cables to the J1 terminal block on the PCB of the first LectroCount XL LED Remote
Display.
8. Replace the rear panel of the display. page 18 Torque Specifications
9. Connect the cable wires from the first LectroCount XL LED Remote Display to the LectroCount electronic register CPU board.
pages 8-12
14