Liquid Controls DMS i1000 EZConnect Operators - Manual (Page 15)

15
seTup
#2 -launch dMs i1000
fleetConnect
The DMS Application List is the launch point for DMS
i1000 FleetConnect software.
To open fleetConnect:
1. Press ALT+ESC.
2. Move the pointer to select FleetConnect and press
Enter.
#3 -Install the fleetConnect
antenna for the eZConnect button
reader
When the EZConnect button reader is attached to a
RFID button, a RF transceiver inside the EZConnect
transmits the RFID button number to the DMS i1000.
In order to receive the RF signal, the DMS i1000 must
be equipped with the FleetConnect antenna. The
FleetConnect antenna plugs into the back of the DMS
i1000 and is easily affixed to the roof of the truck cab.
To install the fleetConnect antenna:
1. There is a heavy magnet in the bottom of the
FleetConnect antenna. Find a high spot on the delivery
truck, preferably the top of the truck cab, and set the
antenna down so the magnet sticks securely to the
surface.
2. Find a pathway for the antenna cable into the inside
of the cab and the DMS i1000 antenna port. If a more
convenient option isn’t apparent, use the same hole as
the LCR-II cables.
3. Run the antenna cord tight to the truck. Secure it so there
is no slack along the pathway. Tie off any excess cord in
the cab next to the DMS i1000.
4. Screw the antenna cable into the DMS i1000 antenna
port.
Liquid Controls recommends using split loom for
the antenna wire. It protects the wire and is easier
to ziptie to the truck.
FleetConnect Antenna
DMS i1000 Antenna Port