Liquid Controls DMS i1000 EZConnect Operators - Manual (Page 13)

13
fleetConnect dMs i1000 setup overview
There are four steps that must be completed before fuelers can begin fuel delivery with FleetConnect. The first
step, Load FleetConnect Database onto the DMS i1000, entails moving data from the office PC to the DMS i1000.
The second step, Launch DMS i1000 FleetConnect, includes starting up the DMS i1000 FleetConnect application
software. The third step, Install the FleetConnect Antenna for the EZConnect Button Reader, comprises of installing
an antenna onto the roof of the truck cab and plugging it into the DMS i1000 antenna port. The fourth and final step,
Set EZConnect Radio Address, requires setting the EZConnects to a unique address so they can transmit without
interference.
dMs I1000 fleeTConneCT seTup prerequIsITes
This manual assumes that FleetConnect Office has been setup, the FleetConnect database is loaded onto the office
PC, the RFID buttons have been mapped into the database and attached to the vehicles near the fueling point, and
the DB Manager software is installed (if using cellular or RF data transmissions).
The following installation and setup must be completed prior to setup of the dMs i1000 fleetConnect:
1. Meter system installed
2. LectroCount Register(s) Installation (EM100-10 or EM150-10)
3. LectroCount Register(s) Setup (EM100-10 or EM150-11)
4. DMS i1000 Installation (EM200-10)
5. DMS i1000 Setup (EM200-11)
6. DB Manager (EM200-21) optional
7. FleetConnect Office Setup (EM200-14)
dMs I1000 fleeTConneCT seTup
After all of the setup prerequisites are fulfilled, only four steps are required before FleetConnect DMS i1000 is ready
for daily use.
sTep 1 Load the FleetConnect database onto the DMS i1000 (Retrieve Database from Office).
This step is also documented in the FleetConnect Office Setup (EM200-14)
sTep 2 Launch DMS i1000 FleetConnect.
sTep 3 Install the FleetConnect Antenna for the EZConnect Button Reader.
sTep 4 Set the EZConnect button readers radio addresses so that they are all unique.
This step is only required if more than one EZConnect button reader is operating in close proximity to another.
dMs i1000 fleetConnect security
FleetConnect provides three sets of security checks: the fueler logon password, the database management password,
and the LCRHost and LCP File Server password. The fueler logon password protects access to FleetConnect’s
fuel delivery functions (see FleetConnect Office manual EM200-15). The database management password protects
access to the FleetConnect database. The LCRHost and LCP File Server password protects access to network setup,
calibration, and file management functions (see DMS Setup and Operation Manual EM200-12).
seTup