Liquid Controls DMS i1000 EZConnect Operators - Manual (Page 14)

14
USB (F3) activates the USB memory device
Done (F5) opens Fueler Logon or Fill Vehicles screen, or DMS
Application List screen
Util (F1) opens System Utilities (1/3) See page 12 EM200-11
Data (F5) opens Database Management screen
#1 -load fleetConnect database
onto the dMs i1000
Liquid Controls recommends using a USB memory
device for the initial loading of the FleetConnect
database because of the large amount of data to be
uploaded. Transmitting a large amount of data wirelessly
can be time consuming and, for cellular transmissions,
costly.
To transfer the latest FleetConnect Office
database to the dMs i1000s via usb device:
1. Using the office PC, name a USB memory device DMS_
USB and create a folder named DMS in it. (USB memory
devices from Liquid Controls are preconfigured with
these settings.)
2. Copy the .502 and .slf files from the C:\DMS folder into
the D:\DMS_USB\DMS folder on the USB memory
device.
3. Remove the USB memory device from the office
computer and plug it into a DMS i1000.
4. On the DMS i1000 lap pad, push ALT and ESC
simultaneously to open the DMS Application
List .
5. Press F5 ( Data) to open Database Management .
6. Press F3 ( USB ) to boot the USB Drive.
7. Move the pointer to Retrieve Entire Database
and push Enter.
8. Move the pointer to USB Memory Device as
the Receive Mechanism and press Enter. The
Retrieving Database screen will appear while the
database loads onto the DMS i1000.
9. Press Enter upon successful retrieval of the database
files.
10. Repeat steps 3-9 until all trucks equipped with DMS
i1000s are loaded with the FleetConnect database.
seTup
The Retrieve Database Updates command inside
the DMS i1000 FleetConnect program will not
upload the whole database, only .502 and .slf files.
Every DMS i1000 is supplied with a USB Flash
Memory Device configured for immediate use.
While the DMS i1000 displays the DMS Application List
screen, it is disabled from the LectroCount register(s).
When the DMS i1000 is disabled, deliveries can be made
with the register’s RUN and PRINT settings.
These instructions are also included in the
FleetConnect Office Setup (EM200-14) manual.
.502 and .slf files are created during FleetConnect
Office setup.
After initial setup, choose Retrieve Database Updates to
update only those files that have changed. Follow the same
procedure as above, but for step 8, select the Radio option,
instead of USB Memory Device, then press Enter.
Transfer Database Wirelessly