DoorKing 1833 PC Programmable - Manual (Page 45)

1835-065-E-7-13 43
3.6 Programming Device Codes - 1833, 1835, 1837 Only
Device codes MUST be five (5) digits in length and are typically used for a remote Weigand card reader or transmitter devices.
Each device code that you enter must be assigned to a directory code that you select (that was programmed in section 3.5.2).
Up to 25 device codes can be entered under a single directory code, up to a maximum of 8,000 total device codes for the entry
system. You cannot duplicate device codes.
1. Press and enter your four-digit MASTER CODE (beep).
2. Enter the existing directory code (section 3.5.2 or 3.5.4) that the device code will be assigned to (1, 2, 3 or 4 digits, section
3.5.1), then press (beep).
3. Choose and enter a five-digit device code, then press (beep).
4. Repeat steps 2 and 3 to enter additional device codes. (You cannot duplicate device codes)
5. Press together to end this programming sequence (beeeeeep).
?? ?? ?? ??
00
OPER OPER
77
PQRS PQRS
00
OPER OPER
This program sequence enters device (card, transmitter, digital) codes into the system memory.
3.6.1 Programming Five-Digit Device Codes
1. Press and enter your four-digit MASTER CODE (beep).
2. Enter the existing directory code (section 3.5.2 or 3.5.4) that the desired device code has been assigned to (1, 2, 3 or 4
digits, section 3.5.1), then press (beep).
3. Enter the desired five-digit device code, then press (beep).
4. Repeat steps 2 and 3 to delete additional desired device codes.
5. Press together to end this programming sequence (beeeeeep).
?? ?? ?? ??
11
SP SP
77
PQRS PQRS
00
OPER OPER
This program sequence deletes individual device codes.
3.6.2 Deleting Device Codes
This program sequence allows you to use (enable) or not use (disable) facility codes.
3.6.3 Enabling Facility Codes
1. Press and enter your four-digit MASTER CODE (beep).
2. Enter (beep) to disable facility codes, or enter (beep) to enable facility codes
3. Press together to end this programming sequence (beeeeeep).
?? ?? ?? ??
22
ABC ABC
77
PQRS PQRS
00
OPER OPER
00
OPER OPER
11
SP SP
This program sequence enters device facility codes into the system memory. Up to 10 facility codes (reference numbers 0
through 9) may be programmed. Valid facility codes are 000 – 255.
3.6.4 Programming Facility Codes
1. Press and enter your four-digit MASTER CODE (beep).
2. Enter the single-digit first facility code reference number (0 – 9), then press (beep).
3. Enter the three-digit facility code, then press (beep).
4. Repeat steps 2 and 3 to enter additional facility codes.
5. Press together to end this programming sequence (beeeeeep).
?? ?? ?? ??
33
DEF DEF
77
PQRS PQRS
00
OPER OPER