DoorKing 1803 Entry System User Manual
Owner’s manual
This manual is related to the following products:
Table of contents
Document Outline
- SECTION 1 - INSTALLATION
- 1.1 Installation Guidelines
- 1.2 Surface Mount 1803 and 1810 Units
- 1.3 Surface Mount 1803 and 1810 Units with Recess Box
- 1.4 Flush Mount 1803 and 1810 Units
- 1.5 Flush Mount Rough-in Box (applies to 1803 and 1810 only)
- 1.6 Flush Mount Trim Ring (use with 1803 and 1810 units only)
- 1.7 Flush Mount Surface Mounting Kit (use with 1803 and 1810 units only)
- 1.8 1808 Surface Mount Only
- 1.9 Memory Chip Installation
- 1.10 Postal Lock Installation
- SECTION 2 – WIRING & ADJUSTMENTS
- SECTION 3 – PROGRAMMING
- Programming from the Keypad
- Programming from an Offsite Location
- Programming Notes
- 3.1 General Programming
- 3.1.1 Master Code
- 3.1.2 Single or Multiple Systems
- 3.1.3 Relay Strike Time
- 3.1.4 Open Tone ON / OFF (Rev L boards and higher only)
- 3.1.5 Talk Time
- 3.1.6 Tone Open Numbers
- 3.1.7 Switch Input Programming
- 3.1.8 Touch-tone / Rotary-dial
- 3.1.9 Number of Rings to Answer
- 3.1.11 Keypad Function
- 3.1.12 Star (*) Key Function
- 3.1.13 Automatic Hang-up Function
- 3.2 Phone Number programming
- 3.2.1 Programming the Directory Code Length
- 3.2.2 Programming 7-digit Phone Numbers
- 3.2.3 Programming Area Codes
- 3.2.4 Programming Phone Numbers with Area Code Reference
- 3.2.5 Deleting Individual Phone Numbers
- 3.2.6 Delete All Phone Numbers
- 3.2.7 Display / Delete Phone Numbers
- 3.2.8 Display Phone Numbers with known Directory Codes
- 3.3 Entry Code Programming
- 3.3.1 Four-Digit Entry Code Programming
- 3.3.2 Delete Four-Digit Entry Codes
- 3.3.3 Delete All Four-Digit Entry Codes
- 3.3.4 Four-Digit Entry Code Divide Number
- 3.3.5 Five-Digit Entry Code Programming
- 3.3.6 Delete Five-Digit Entry Codes
- 3.3.7 Delete All Five-Digit Entry Codes
- 3.3.8 Five-Digit Entry Code Divide Number
- 3.4 Time Functions Programming
- SECTION 4 – OPERATING INSTRUCTIONS
- SECTION 5 – MAINTENANCE