Controlled Products Systems Group 1602-090 - Manual (Page 10)

1601-065-L-3-13 8
1.3 Trenching Existing Concrete
Trench path(s) in the existing concrete wide enough for all the conduit runs.
After the conduit has been run, fill the trench with soil to bottom of existing
concrete and tamp down. Pour new concrete with a 4 inch pad height
minimum (Reinforce concrete if possible). Secure the mounting flange to
concrete with 1/2” x 3” sleeve anchors (not supplied). See illustration above
for mounting operator.
1.2 New Concrete Pad
underground depth of the
concrete pad is determined by
soil conditions and local
building codes.
The operator(s) should be
installed with the access
door of the operator
opposite the traffic lane.
The operator(s) should be
installed with the access
door of the operator
opposite the traffic lane.
Remove breather
pin from gear
reducer AFTER the
operator has been
secured in place.
Concrete pad MUST be level.
Note: Bevel the edges of concrete
pad to eliminate water puddling
under the operator.
4” minimum
Reinforced concrete recommended.
Traffic Lane
Secure the mounting
flange to concrete
with 1/2” x 3”
sleeve anchors
(not supplied).
Traffic Lane
Access Door
Sleeve
Anchors
Conduit
CLA SS
CER TIF IED TO CA N/C SA C2 2.2 NO . 2 47
CO NF OR MS TO AN SI/U L-3 25 VEH ICU LA R G AT E O PER AT OR HP
533 82 MO DE L SER IAL VO LT S PH AS E AM PS 60 H z MA X G ATE LO AD Doo rKin g, Inc ., In gle wo od, CA
Access
Door
4” height min
.
Access Door
Approximate position
of conduit runs.
Inside
Operator
Mounting Flange
Mount
operator
centered
on pad.
1/2
2.625”
7.5”
12.375”
2.5”
7.25”
10.75”
11”
12”
23”
23”
Concrete Pad
Traffic Lane
CLASS
CERTIFIED TO CAN/CSA C22.2 NO. 247
CONFORMS TO ANSI/UL-325
VEHICULAR GATE OPERATOR HP
53382
MODEL SERIAL VOLTS PHASE AMPS 60 Hz MAX GATE LOAD DoorKing, Inc., Inglewood, CA
MOVING ARM can cause vehicle damage,
serious injury or death.
STAY CLEAR of arm at all times. NO: Pedestrians Bicycles
Motorcycles
WARNING