Ken Tool Bendix ADB22X-V Air Disc Brakes - Manual (Page 36)

36
5.7.6 Following industry standards, clean and inspect the
hub before installing the rotor. Look for corrosion
and/or damage to the hub and inspect the wheel
speed tone ring. Where necessary, consult the hub
manufacturer's guidelines for more details.
B-B
B
B
3
1 2
4
KEY
1 - Wheel Hub
2 - Splined Disc Rotor
3 - Intermediate Element (Spacer)
4 - Spring Element (Fastener), including retention clips
FIGURE 87 - ROTOR WITH CROSS-SECTION VIEW
FIGURE 88 - ROTOR INSTALLATION
3
1
2
3
KEY
1 - Wheel Hub
2 - Splined Disc Rotor
3 - Intermediate Elements (Spacers)
FIGURE 89 - INTERMEDIATE ELEMENT (SPACER)
INSTALLATION
FIGURE 90 - INTERMEDIATE ELEMENTS (SPACERS) INSTALLED
ROTOR INSTALLATION
5.7.7 See Figures 87 through 91. Place the rotor into
position on the hub. Install the new intermediate
elements (spacers) as shown in Figure 89. With
all the intermediate elements (spacers) correctly
inserted into position, verify that the gap between
the intermediate elements (spacers) and the wheel
hub does not exceed 0.004 in (0.1 mm). If a gap is
found that exceeds this maximum value, verify the
installation of new intermediate elements (spacers).
Replace the wheel hub if the excess gap cannot
be corrected with proper installation of new rotor
retaining hardware.
5.7.8 Install the new fasteners included in the kit in an
evenly-distributed cross-pattern sequence. Torque
to 22.1 ft. lbs. (30 N·m.)