Ken Tool Bendix ADB22X-V Air Disc Brakes - Manual (Page 29)

29
5.6 GUIDE PIN AND BOOT ASSEMBLIES
FIGURE 62 - GUIDE PIN EXPLODED VIEW
Guide Pin
(9)
Guide Bushing
(10)
Inner
Boot
(8)
Inner
Boot
(8)
Cap
(12)
Shear
Adapter
(5) Cap
(4)
Ring
(7)
Ring
(7)
Caliper Bolt
(11)
Adjuster Cap
(Two alternate
caps supplied in kit)
(6)
Caliper Bolt
(3)
Guide Pin
(2)
Bushing
(1)
KIT CONTENTS
Item Description Quantity
1 . . . Bushing . . . . . . . . . . . . . . . . . 1
2 . . . Guide Pin (short) . . . . . . . . . . . . 1
3 . . . Caliper Bolt (Short) . . . . . . . . . . . 1
4 . . . Cap (large). . . . . . . . . . . . . . . . 1
5 . . . Shear Adapter. . . . . . . . . . . . . . 1
6 . . . Adjuster Cap (two versions supplied) . 2
7 . . . Ring . . . . . . . . . . . . . . . . . . . 2
8 . . . Inner Boot . . . . . . . . . . . . . . . . 2
9 . . . Guide Pin (Long) . . . . . . . . . . . . 1
10. . . Guide Bushing (Long) . . . . . . . . . 1
11. . . Caliper Bolt (Long) . . . . . . . . . . . 1
12. . . Cap (small) . . . . . . . . . . . . . . . 1
(White grease also supplied - not shown)
Horizontal
Mounting Bolt
Style Shown:
See Inset Above
for Vertical
Bolt Style (with
bushing).
Vertical
Bolt Style
(with
bushing).
The Bendix DVD (BW7356) shows this procedure.
5.6.1 CAUTION: Follow all safe maintenance
practices, including those listed on page two of
this document. Park the vehicle (by other means
than the foundation brakes) on level ground and
chock the wheels.
Important: If the vehicle is equipped with spring brakes,
cage the spring brakes on all axles to be worked on.
Consult the vehicle manufacturer’s instructions as
necessary.
These procedures are typically carried out with the
caliper/carrier removed from the vehicle (may be
carried out with the air disc brake installed). In cases
where the caliper/carrier assembly is removed from
the vehicle, NEW fasteners must be used and properly
torqued during re-installation. Use only fasteners
approved by the vehicle manufacturer.
Note: This maintenance procedure uses specialized
tools. The full Bendix air disc brake tool kit (K029164),
or Ken-Tool kit (80000), includes the tools needed for the
guide pin and boot installation. See Table 5.