Ken Tool 30170 HUBCAP & WHEEL LOCK REMOVAL KIT - Manual

HUBCAP & WHEEL LOCK
REMOVAL KIT
768 E. North Street ● P. O. Box 9320 ● Akron, Ohio 44305
Toll Free: 888-536-8665 ● Fax: 800-872-4929
Phone: 330-535-7177 ● Fax: 330-535-1345
E-mail: [email protected] ● www.kentool.com
 Quickly remove wire wheel cover locks with variable inside drive keys on GM, Ford and Chrysler
products.
 Easily removes aftermarket wheel locks without damaging the lock or stud.
 Removes and replace GM, Ford, Chrysler and McGard hubcap locks and aftermarket wheel lug
locks...without keys...without waiting!
 GUARANTEED: For one full year against defects in materials and workmanship.
INSTRUCTIONS FOR USE:
Sockets ARE NOT TO BE HAMMERED/POUNDED onto wheel lock. Simply apply pressure against wheel
lock while either running impact gun in reverse, or turning ratchet/wrench counterclockwise with removal
socket attached.
NOTE:
 When using socket with smooth tapered inside profile, run impact gun clockwise for 10 seconds heat-
ing up wheel lock and socket. This will create a temporary shrink-fit bond.
 Pause for 10 seconds.
 Change direction of impact gun to counterclockwise/reverse and, while applying pressure against the
wheel lock, run the impact gun to remove wheel lock. Sometimes a breaker bar and hand turning will
give better results.

MADE IN USA
 Kit Includes: ● GM Hubcap Lock Remover ● GM Sprocket Hubcap Lock Remover ● Ford and
Chrysler Hubcap Lock Remover ● Large Universal Locking Lug Nut Remover ● Small Hubcap Lock
Remover for 1986-88 Buick, Also Fits Stripped 18MM Lug Nuts ● Lug Nut Remover Punch ● Durable
Plastic Carrying Case ● Directions for Use.
PART NO. 30170