Ken Tool 32610 Wrench Support Stand - Manual

Commercial-Duty
Wrench Support Stand
Warning:
This tool is to be used as a lug nut wrench support only.
Do not use when any components are damaged.
Maximum load 300lbs.
Instructions :
Put wrench on lug nut.
Raise support to wrench height so wrench is cradled in the stand.
Position wrench/leverage bar at horizontal angle with ground
Push down on one side of the wrench/leverage bar to break the lug nut loose or
to tighten the lug nut.
Continue with the same process until all lug nuts have been loosened or
tightened.
ITEM #32610
Use to support
impact wrench, torque wrench,
double-end truck wrench or 4-way lug wrench
when removing or replacing lug nuts
32610-98
Rev. 09/06/13