INTELLINET NETWORK ICC-130 User Manual - Manual (Page 64)

- 64 -
Date Time - Current Date / Time
Refer to section 5.2.1.
Security - Account
Refer to section 5.2.1.
Security - IP Address Filter
Once you enabled it, the listed IP address are allowed or denied access to the
network camera. Add the IP address that you’d like to allow or deny, select
allow or deny from the list and save it.
HTTPS
Secure Sockets Layer (SSL) is a cryptographic protocol that provides security
for communications over networks such as the Internet.
HTTPS is a URI scheme used to indicate a secure HTTP connection (SSL
encrypted). It is syntactically similar to the http:// scheme that is normally
used for accessing resources using HTTP. The differences are that SSL-
encrypted connections always begin with https:// instead of http://. HTTPS
connections use TCP port 443 by default, compared to standard HTTP
connections, which use port 80.Create & Install: Create a self-signed certificate
for HTTPS to recognize.
Installed Certificate: Display or remove the properties of the installed
certificate.
HTTPS Connection Policy: Set HTTPS connection policy for different level of
users.
To use the HTTPS encryption, please set up “Create self-signed certificate” for
the first time you use the HTTPS function, and then set up the connection policy
for different users.
Note: When enable HTTPS with RTSP on mode, the IP Camera only protect the
setting such as username and password and do not protect video and audio.
When enable HTTPS with RTSP off mode, the IP Camera will protect all setting
including video and audio.
Network - Basic
Refer to section 5.2.1.