Clear-Com WTR-680 - Manual (Page 8)

Con trols and Con nec tions - Rear Panel
1. Re ceive An tenna - Fe male “TNC” Con nec tor. Color band
on an tenna must match color dot on base sta tion.
2. Trans mit Power Switch – HIGH = Trans mit ters at full
power. NOR MAL = Trans mit ters 10dB be low full power.
3. Trans mit ON/OFF Switch – Turns the trans mit ters on or off.
4. I/C Se lect Switch – Set to the ap pro pri ate 2-wire in ter com
type be ing in ter faced to the unit. Set to ei ther Clear-Com,
Telex, or RTS.
5. Base Sta tion Link Jack – When two base sta tions are
con nected through this jack, it al lows wire less talk around
(WTA) from the beltpacks to be routed from the sys tem
with it’s trans mit ters off to the sys tem with it’s trans mit ters
on.
6. Re lay Con tact – A dry con tact clo sure which is ac ti vated
when a beltpack user presses the stage an nounce (SA) but -
ton. Normally Open (NO). One amp at 24V max i mum.
7. In ter com A – In ter face to wired in ter com sys tem A.
2-Wire – Male and fe male 3-pin XLR con nec tors
wired in par al lel. The con nec tors are switched to the
ap pro pri ate in ter com con fig u ra tion via the I/C Se lect
Switch.
4-Wire – An RJ-45 type jack com pat i ble with “Ma -
trix” type in ter com sys tems.
8. In ter com B – In ter face to wired in ter com sys tem B.
2-Wire – Male and fe male 3-pin XLR con nec tors
wired in par al lel. The con nec tors are switched to the
ap pro pri ate in ter com con fig u ra tion via the I/C Se lect
Switch.
4-Wire – An RJ-45 type jack com pat i ble with “Ma -
trix” type in ter com sys tems.
9. Aux il iary In put/Out put – One 3-pin fe male XLR in put
con nec tor and one 3-pin male XLR out put con nec tor.
10. Stage An nounce Out put – Passes the au dio from any of
the base sta tion’s beltpacks that have se lected stage an -
nounce (SA).
11. Power – IEC re cep ta cle. Ac cepts 100 – 240 VAC, 50 – 60 Hz.
12. Trans mit An tenna - Fe male “TNC” Con nec tor. Color
band on an tenna must match color dot on base sta tion.
2-2
PUSH PUSH PUSH
1
2 3 4 5 6 7 8 9 10 11
12
RECEIVE
HIGH
ON
NORM
OFF
TRANSMIT
POWER
I/C
TELEX CLEAR-COM
RTS
BASE STATION
LINK RELAY
CONTACT
INTERCOM A
2-WIRE
L
O
O
P
T
H
R
U
4-WIRE
INTERCOM B
2-WIRE
L
O
O
P
T
H
R
U
4-WIRE
AUXILIARY AUDIO
INPUT OUTPUT
STAGE ANNOUNCE
OUTPUT POWER
100-240 VAC 50-60 Hz
TRANSMIT
MADE IN USA
WBS-680
FCC ID: B5DM514
CANADA 1321231218A
R
Intercom Systems
Fig ure 3
WBS-680 - Rear Panel