Clear-Com WTR-680 - Manual (Page 37)

Power-Up Screen
• This screen is dis played only on power up, first use de -
fault, and fac tory de fault.
• The 1 st up per-right-corner num ber dis plays the base’s
soft ware re vi sion. The sin gle ver sion num ber in cre ments
for changes in op er a tional soft ware.
• The 2
nd
up per-right-corner num ber dis plays the base’s
chan nel map (fre quency plan) ver sion. The sin gle ver sion
num ber in cre ments for changes in the chan nel map.
• Once the power-up screen is dis played, it will change to
the op er at ing screen af ter a few sec onds.
Op er ating Screen
• Screen is dis played af ter power-up screen.
• Sys tem will re vert to this screen if no ac tiv ity is de tected
on the LCD dis play but tons af ter 3 min utes.
• Screen dis plays cur rent sta tus of the sys tem.
Beltpack Ac tiv ity Code Def i ni tions:
7-5
Clear-Com
S
C60001 B30001
Group 03A
T1
4
R1 tx
On
On
Off
Ch B
TA A
Operating Screen
2
3
T1
2
no
no tx = No Beltpack Trans mit Car rier De tected
Off = Re ceiver is not se lected on front panel
Ch A = Beltpack au dio is on Channel A
Ch B = Beltpack au dio is on Chan nel B
Ch A&B = Beltpack au dio is on Chan nel A and B (WTR-682 only)
TA A
= Beltpack Chan nel B Talk Around Ac tive
TA B = Beltpack Chan nel A Talk Around Ac tive
TA A&B = Beltpack Chan nel A and B Talk Around Ac tive (WTR-682 only)
SA
= Beltpack Stage An nounce Ac tive
Power-Up Screen
NOTE: Older ver sions of WBS-680 soft ware do not sup port the de tec tion of WTR-682 “Ch A&B”
and “TA A&B” con trol tones.