Clear-Com WTR-680 - Manual (Page 42)

Spe cial Key Se quences
Lock out
• Press [UP]+[DOWN] for 3 sec onds to lock or un lock the
base sta tion. Pressing [MENU] will still func tion to view
screens, but [SET] will no lon ger start any ed it ing. Scan,
First use, Fac tory de fault are no lon ger ac ces si ble. The in -
ter com chan nel A and B front panel 2-wire/4-wire se lec -
tion is also locked into place. A pad
lock icon will be
dis played on the sec ond line of the dis play to the far left
as an in di ca tion that the base sta tion is locked out.
Copy
• Press [SET]+[DOWN] for 3 sec onds to copy any cur -
rently dis played group to a user-programmable group.
Copy can be done from the group/chan nel se lect,
group/fre
quency se lect or fre quency edit screen. Once
pressed, the words, “Copy to” are dis played on the screen
with the first empty user-programmable group flash ing. If
all the user-programmed groups were full, than the first
programable group is dis played. The [UP] or [DOWN]
but tons may be used to se lect a different user-programmable
group if de sired. Pressing [SET] pastes fre quen cies/chan -
nels to the group and take the user to the fre quency edit
screen with “T1” flash ing.
1
st
Use De fault
• Press [MENU] while turn ing on the base sta tion to en ter
the 1
st
use de fault setup screen. This places the unit on
group 01A with the four re ceiv ers set to chan nels 1- 4 of
the group. Any user-programmed fre quen cies that had
been en tered pre vi ously are re tained. If lock out had
been ac ti vated, the beltpack co mes up where it was last
left re gard less of [MENU] be ing pressed on power-up.
Fac tory De fault
• Pressing all four but tons [MENU]+[SET]+[UP]+[DOWN]
at the same time for 3 sec onds places the unit on group
01A with the four re ceiv ers set to chan nels 1 – 4 of that
group. This is just like base sta tion 1
st use de fault, ex cept
that all user-programmed fre quen cies that had been en -
tered pre vi ously are erased. This func tion may take sev -
eral sec onds. If lock out had been ac ti vated, the beltpack
co mes up where it was last left re gard less of these four
keys be ing pressed.
7-10