Clear-Com WTR-680 - Manual (Page 29)

Beltpack Set-up
Bat tery In stal la tion
En sure that the On/Off vol ume con trol knob is turned off.
Press down and hold down the bat tery re lease latch, slide the
bat tery pack about 1/8 inch back, to ward latch, un til it stops.
Then lift bat tery pack out. Re place bat ter ies as fol lows:
5-11
1. Open the bat tery pack by in sert ing
fin ger nail and lift ing.
2. Pull bat tery strap to re move low
or dead bat ter ies.
WARNING
Do not place an al ka line WTR bat -
tery pack in any bat tery charger. Se -
vere charger and bat
tery pack
dam age may re sult.
3. Load new bat ter ies fol low ing the
po lar ity as shown in bat tery case
4. Start load ing at the end of the case where
the strap is at tached to the case.
5. Be sure strap goes un der bat ter ies.
6. Tuck end of strap un der door
when plac ing the bat tery cover
back on the case.
Fig ure 28
Bat tery Installation