Clear-Com WTR-680 - Manual (Page 59)

WTR-682 Menu Struc ture
Re ceive 2 Screen
The Re ceive 2 screen al lows the user to set the beltpack re -
ceive 2 fre quency. This cor re sponds to the base sta tion’s trans -
mit 2 fre quency. In fac tory-defined groups re ceiver 2 is not
change able. User-programmable groups will al low the user to
change the fre quency in 25kHz steps.
•
Press [MENU] three times from the group/chan nel screen
to ar rive at the re ceive 2 fre quency screen.
•
(User-Programmable Groups Only) Press [SET] to edit
the fre
quency. The num ber will start flash ing. Fac -
tory-defined groups can’t be changed, so press ing set will
do noth ing at this screen. User-programmed groups will
start flash ing and al low the user to change the fre quency
in 25kHz steps.
•
(User-Pro gram ma ble Groups Only) Use the [UP]/[DOWN]
ar row but tons to change the fre quency.
•
(User-Programmable Groups Only) Press [SET] to place
the beltpack on the fre
quency se lected. If set is held
down, dur ing that time the group is dis played so the user
is aware of what group the unit has been placed. Once set
is re
leased, the unit re turns to the re ceive 2 fre quency
screen with noth ing flash ing.
•
(User-Programmable Groups Only) Pressing [SET] once
more will start the ed it ing se quence over again. Pressing
[MENU] dur ing re ceive 2 fre quency edit will end ed it ing
and send the user back to the re ceive 2 screen with out any
changes.
7-27
565.350
[SET]
565.350
R2
R2
567.850
[SET] IS HELD DOWN
27u
GP
[SET] IS RELEASED
END
567.850
[UP] / [DOWN]
R2
R2
Re ceive 2 Screen