Clear-Com WTR-680 - Manual (Page 11)

WTR-680 Beltpack
Con trols and Con nec tions - Top Panel
Fig ure 4
WTR-680 Top Panel
1. On/Off & Vol ume Con trol – Turns the beltpack power
on and con trols head set vol ume.
2. Wire less Talk Around (WTA) – When pressed, the user’s
au dio is dis con nected from the wired in ter com, aux il iary
in
put/out put and the base sta tion’s lo cal head set. Other
beltpack us ers, on that au dio chan nel, can hear the user as
nor mal. The but ton ac ti vates the nearby red LED as well
as the “TALK” LED, #6, when pressed.
3. Stage An nounce (SA) –When pressed, the user’s au dio is
routed to the stage an nounce con nec tor on the back of the
base sta tion. The user also loses their sidetone as an in di -
ca tion that stage an nounce is ac ti vated. The other wire less
beltpacks and wired us ers do not hear the user’s au dio.
The but ton is non-latching and ac ti vates the nearby red
LED as well as the “TALK” LED, #6, when pressed.
4. Au dio Chan nel – Al lows user to se lect ei ther au dio
chan nel A or B.
5. Bat/Overmod Light – Light will flash once when unit is
turned on if the bat tery is good. If the light stays on, bat -
tery is low. If the light does not flash, bat tery is dead. A
nor
mal mi cro phone gain set ting will cause the LED to
flash at the be gin ning of most words at nor mal speech lev -
els. If the gain is too high, the LED will be red dur ing the
com plete word at nor mal speech lev els.
6. Talk Light – LED is on when the talk but ton, SA or WTA
is ac tive.
7. Talk But ton – Press to en able the au dio path from the lo -
cal head set mi cro phone. The “TALK” LED, #6, will turn
red when en abled. A quick press and re lease latches the
talk func tion, un less latch ing has been dis abled. Holding
the but ton for over ½ a sec ond will cause the au dio path to
be en abled only for as long as the but ton is held. If the talk
func tion is latched on, press ing the talk but ton again will
turn it off.
3-1
SA
WTA
A B
CHANNEL
BAT/OM TALK
TALK
1 2 4 5 6
7
3
Vol
Off
S
ection
3