Clear-Com WTR-680 - Manual (Page 66)

WTR-682 Menu Struc ture
Spe cial Key Se quences
Lock out
•
Press [UP]+[DOWN] for 3 sec onds to lock or un lock the
beltpack. The words “Loc on” will be dis played when
the fea
ture is ac ti vated, “Loc oFF” will be dis played
when the beltpack is un locked. Press ing [MENU] will
still func tion to view screens, but [SET] will no lon ger
start any ed it ing. Scan, First use, Fac tory de fault, and
Fea ture en able/dis able are no lon ger ac ces si ble. The
words "Loc out" will be flashed on the screen if any ed it -
ing is at tempted dur ing lock out.
1
st
Use De fault
•
Press [MENU] while turn ing on the beltpack to en ter the
1
st use de fault setup screen. This places the unit on group
01A with chan nel 01 flash ing. Any user-programmed
fre quen cies that had been en tered pre vi ously are re -
tained. The beltpacks must now be set to dif fer ent trans -
mit chan
nels us ing the [UP]/[DOWN] but tons. Then
[SET] is hit to place the units on those chan nels. If lock -
out had been ac ti vated, the beltpack co mes up where it
was last left re
gard less of [MENU] be ing pressed on
power-up.
Fac tory De fault
•
Press ing all four but tons [ MENU]+[SET]+[UP]+[DOWN]
at the same time places the unit on group 01A with chan -
nel 01 flash ing, just like beltpack 1
st use de fault, ex cept
the all user-pro grammed fre quen cies that had been en -
tered pre vi ously are erased. The beltpacks must now be
set to dif fer ent trans mit chan nels us ing the [UP]/[DOWN]
but tons. Then [SET] is pressed to place the units on those
chan nels. If lock out had been ac ti vated, the beltpack
co mes up where it was last left re gard less of these four
keys be ing pressed.
7-34