Clear-Com ICS-2003 - Manual (Page 20)

Clear-Com Communication Systems
ICS-2003 Intercom Panel Instruction Manual
1 - 1 2
display, pressing the “up” key will change the key assignment from
talk to listen, from listen to talk with listen, and from talk with listen to
talk. If the selected key is on the lower line pressing the “down” key
does the same. The active assignment is shown in the center of the
screen at the top of the display, a “T” is displayed for a talk
assignment, an “L” for a listen assignment, and “T+L” for a
talk-with-listen assignment.
5. Exit to save changes or abort to abandon the changes.
Warning: All panel selector reassignments take place
immediately upon exiting this function. Active talk and
listen paths will be disconnected when their labels are
removed.
Assign Forced Listens
To add or remove forced listens:
1. Select “select source -> assign destinations” to choose a single
source and assign it to multiple destinations. Select “select
destination -> assign sources” to choose a single destination and
assign multiple sources to it.
2. Choose a panel or interface label.
3. A list of destination or source labels will be displayed depending
upon the assignment method selected. If the label(s) is already
assigned to the selected label, that label will be outlined. To change
a label’s assignment status, select the label and press Enter.
Change Input Level Gain
This menu adjusts the level of the audio signal sent to the frame. Use
the selectors to raise or lower the gain.