Clear-Com HX System Frames - Manual (Page 29)

4.2.1 Installing the Power Supplies
The Eclipse HX-Omega system’s DC power supplies run on AC mains power.
Two identical Euro Cassette power supplies are provided to ensure that every matrix will
have redundant power (ensuring that the matrix will continue to operate even if one supply
output fails).
Each of the power supplies must be connected to a dedicated branch of AC mains power.
The matrix will continue to operate even if one of the AC power branches fails.
Clear-Com supplies each matrix with power supplies already installed. When the matrix is
installed connect the power supplies to AC mains power using the IEC power connectors on
the matrix’s rear panel.
A fully equipped Eclipse HX-Omega matrix (for example, 2 CPU cards, 4 E-QUE cards and
11 MVX-A16 cards) requires 100 - 240 VAC at 50 - 60 Hz with a maximum dissipation of
300W.
4.2.2 Installing the rear connector panels
The rear panel of the matrix is constructed of modular, individually-installable connector
panels. Each port or expansion card has a corresponding rear-connector panel:
• Each MVX-A16 rear connector panel contains 16 RJ-45 connectors.
• E-FIB rear cards contain two fiber connectors.
• E-QUE, IVC-32 and LMC-64 rear cards contain 11 RJ-45 connectors.
• E-MADI64 rear cards contain a MADI fiber connector, MADI input and output coaxial
cable connectors, and a coaxial Video / Word clock input.
Note:
Clear-Com ships each matrix with the required number of rear-connector panels already
installed. Blank rear panels fill unused card slots.
To add a rear panel to the matrix:
1. Remove the desired blank rear panel by loosening the screws and pulling the panel
out. The screws are attached and cannot be removed.
2. Install the new rear panel by sliding the card into the card’s guides at the top and
bottom of the Eclipse HX-Omega chassis.
3. Tighten all of the screws on the rear panel.
29 Eclipse HX-Omega User Guide