Clear-Com HX System Frames - Manual (Page 28)

The minimum at which the data may remain intact is around 1.5V but normally the battery
should be replaced before the voltage drops to this level.
Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type.
Lithium batteries can overheat or explode if they are shorted. When handling
the CPU card or a loose battery, do not touch any external electrical
conductors to the battery’s terminals or circuits to which the terminals are
connected.
Note:
When servicing the battery, make sure that the jumper on CON9 is connecting pin 2
(common) to either pin 1 (on) or to pin 2 (off). If the common is left floating, the CPU may
behave unpredictably. For example, the microprocessor may reset itself intermittently.
4.2 Installing the Eclipse HX-Omega
The following overview gives a summary of the steps required to install an Eclipse HX-
Omega matrix. More detailed information on each step is provided in the sections that follow.
To install an Eclipse HX-Omega matrix:
1. Remove the Eclipse HX-Omega matrix chassis from its shipping carton.
2. Install the Eclipse HX-Omega to the standard 19 inch rack.
Environmental note:
Leave at least 2 inches (51 mm) of clearance on all sides of the matrix chassis to
ensure proper airflow. Do not block ventilation vents.
3. Check the position of circuit cards, power supplies, and rear-connector panels. Later
sections in this chapter give more information on these items.
4. Apply AC power to the unit. The unit has two separate AC power entry connectors for
the two separate power supplies in the system.
28 Eclipse HX-Omega User Guide