Clear-Com HX System Frames - Manual (Page 25)

4 Installing the
Eclipse HX-Omega
This chapter describes how to install the Eclipse HX-Omega matrix, including the power
supplies, connector panels, CPU cards, the port and expansion cards.
It also describes how to connect interface cards, interface modules and intercom (user)
panels to the matrix.
Note:
For an overview of the Eclipse HX-Omega matrix, including cards, interface modules and
compatible intercom panels, see 3
Overview .
4.1 Before you begin the installation
4.1.1 Checking the shipment
When the Eclipse HX-Omega is received, inspect the boxes for shipping damage. Report
any shipping damage to the carrier.
Note:
The Eclipse HX distributor is not responsible for shipping damage.
Check the packing list and verify that every item on the list has been received. Save all
packing materials in the event that any items need to be returned.
4.1.2 Unpacking the System
When the Eclipse HX-Omega system is received the circuit cards, power supplies, and rear-
connector panels are pre-installed in the matrix chassis. The customer must supply:
• The standard 19-inch rack in which to install the matrix.
• A personal computer to run the EHX configuration software
Note: For the minimum and recommended requirements for the PC running the EHX
software, see 12.24 Minimum PC requirements (for EHX software) and
12.25 Recommended PC requirements (for EHX software)
• Shielded CAT-5 cables (to connect the matrix to panels and interfaces).