Clear-Com HX System Frames - Manual (Page 114)

Key to Figure 41: IVC-32 rear panel connectors
Feature Description
A
LAN port (RJ-45)
B
DECT sync ports:
DECT Ref in (Not used)
DECT Ref out (Not used)
C
E1 / T1 Port 1 (Not used)
E1 / T1 Port 2 (Not used)
E1 / T1 Port 3 (Not used)
E1 / T1 Port 4 (Not used)
D
E1 / T1 Port 5 (Not used)
E1 / T1 Port 6 (Not used)
E1 / T1 Port 7 (Not used)
E1 / T1 Port 8 (Not used)
Table 21: Key to IVC-32 rear panel connectors
Note:
The E1/T1 and DECT ports are not used on the IVC-32 interface and should not be
connected.
9.3 IVC-32 interface card applications
The IVC-32 interface may be used to connect:
• V-Series IP panels to an Eclipse HX matrix.
• Different Eclipse HX Matrices to each other using IP linking and trunking.
• Provide a link to a Concert Instant Voice Router (IV-R) server.
9.3.1 V-Series IP Panels
V-Series panels with V5.1 or later software may be enabled to communicate with an Eclipse
HX-Omega or Eclipse HX-Median matrix over an IP network via the IVC-32 interface.
The advantage of using IP communication is that it enables remote panels to communicate
over an existing local (LAN) or wide area (WAN) network rather than requiring a dedicated
link.
114 Eclipse HX-Omega User Guide