Hydrotech 6200 SXT Automatic Meter Initiated Water Softener - Manual (Page 23)

22
Res-Up® Feeder Installation Instructions
Res-Up Feeders attach to your brine tank and automatically dispense the Res-Up cleaner into the brine solution where it
cleans the resin during the regeneration cycle.
The feeder hooks onto the tube inside your brine tank and you just pour some chemical in it and your water softener should
last significanly longer. A res-up feeder is essential if your raw water contains measurable amounts of iron.
Res-up Feeder Bottle (Chemical sold Separately)
The 12 cc feeder (Part # 33010) is for softeners up to 64,000 grains (2 ft3 of resin) .
The 30 cc feeder (Part # 33018) is for larger softeners over 64,000 grains.
Pro-Res Care Chemicals
Item #45147 Pro-ResCare - Gallon
Item #45148 Pro-ResCare - Quart
1. Remove top cover, fill the
Res-Up® Feeder (plastic
container) to the top with water
so that the wick retaining clip,
tube and wick are wetted, allow
to soak for 15 minutes or more.
2. Empty water and pull tube and
wick through Feeder until slack is
removed from inside. The outlet
end tube and wick must be below
the bottom level of the Res-Up®
Feeder.
3. Drill two 1/4” holes in brine tank
as shown.
4. Drill a 5/8” hole in the
brine well cap.
5. Clip mounting bracket over
feeder with “hooks” pointed up.
Insert end of tube in the brine well
cap and mounting bracket with
the 1/4” holes in the brine tank,
rotating feeder downward into
position as shown in Figure 1.
6. Fill Feeder with Res-Up® Cleaner
to “Fill Line” on label.
7. Replace cover on Feeder and
automatic feeding will occur in a
few hours.
5/8" hole in brine
well cap
Res-up feeder
1/4” Holes