beautypg.com

Burkert Type 8691 User Manual

Page 19

background image

19

Installation

3. install the control head

noTe!

Damaged printed circuit board or malfunction.

▶ Ensure that the puck is situated flat on the guide rail.

Align the puck and the control head until
1. the puck can be inserted into the guide rail of the control head (see “Figure 7”) and
2. the connection pieces of the control head can be inserted into the pilot air ports of the actuator
(see “Figure 8”).

Guide rail

Puck

Figure 7:

Aligning the puck

Push the control head, without turning it, onto the actuator until no gap is visible on the form seal.

noTe!

too high torque when screwing in the fastening screw does not ensure degree of protection ip65 /
ip67.

▶ The fastening screws may be tightened to a maximum torque of 0.5 Nm only.

Attach the control head to the actuator using the two side fastening screws. In doing so, tighten the screws
only hand-tight (max. torque: 0.5 Nm).

Connection pieces

Pilot air ports

Fastening screws

max. 0,5 Nm

Figure 8:

Installation of control head, series 21xx

english

Type 8691