Burkert Type 8690 - Manual (Page 6)

6
Authorizeduse
2 auThOrizeD use
non-authorized use of the pneumatic control unit type
8690 may be a hazard to people, nearby equipment and the
environment.
The device is designed to be mounted on pneumatic actuators of
process valves for the control of media.
▶ Do not expose the device to direct sunlight.
▶ Use according to the authorized data, operating conditions and
conditions of use specified in the contract documents and oper-
ating instructions. These are described in the chapter entitled “6
Technical data”.
▶ The device may be used only in conjunction with third-party devices
and components recommended and authorized by Bürkert.
▶ In view of the large number of options for use, before installation, it
is essential to study and if necessary to test whether the Pneumatic
Control Unit is suitable for the actual use planned.
▶ Correct transportation, correct storage and installation and care-
ful use and maintenance are essential for reliable and faultless
operation.
▶ Use the Pneumatic Control Unit Type 8690 only as intended.
2.1 restrictions
If exporting the system/device, observe any existing restrictions.
3 Basic safeTy
insTrucTiOns
These safety instructions do not make allowance for any
• contingencies and events which may arise during the installation,
operation and maintenance of the devices.
• local safety regulations, whereby the operator is responsible for their
compliance, by the installation personnel too.
Danger!
risk of injury from high pressure in the equipment/device.
▶ Before working on equipment or device, switch off the pressure
and deaerate/drain lines.
risk of electric shock.
▶ Before working on equipment or device, switch off the power
supply and secure to prevent reactivation.
▶ Observe applicable accident prevention and safety regulations
for electrical equipment.
english
Type 8690