beautypg.com

4 rotating the actuator module – Burkert Type 8690 User Manual

Page 18

background image

18

Installation

7.4

rotating the actuator module

The actuator module (Pneumatic Control Unit and actuator)
can be rotated for straight seat valves and angle seat valves
only.

The position of the connections can be aligned steplessly by rotating the
actuator module (Pneumatic Control Unit and actuator) through 360°.

Process valves Type 2100 and 2100: Only the entire actuator
module can be rotated. The Pneumatic Control Unit cannot
be rotated contrary to the actuator.
The process valve must be in the open position for alignment
of the actuator module.

Danger!

risk of injury from high pressure in the equipment/device.

▶ Before working on equipment or device, switch off the pressure

and deaerate/drain lines.

procedure:

Clamp valve body in a holding device (only required if the process
valve has not yet been installed).

Control function A: Open process valve.

Actuator
module

Key contour

Hexagon

Nipple

with hexagon

without hexagon

Nipple

Fig. 13: Rotating the actuator module

Using a suitable open-end wrench, counter the wrench flat on
the pipe.

Actuator module without hexagon:
Fit special key

2)

exactly in the key contour on the underside of

the actuator.

Actuator module with hexagon:
Place suitable open-end wrench on the hexagon of the actuator.

2)

The special key (665702) is available from your Bürkert sales office.

english

Type 8690