FlexLink WL322 (322 мм) Монтаж - Manual (Page 42)

Troubleshooting
38 5683EN-1
13.4 Noise
13.5 Abnormal wear on plastic parts
Cause Corrective action
Worn or damaged bear-
ings in drive unit Check/replace drive unit.
Damaged/badly fitted slide
rail Check the free running of the conveyor
belt, especially in slide rail joints.
Excessive conveyor speed Lower speed.
Check actual load against recommended
loading.
Incorrect conveyor belt
tension Lengthen/shorten conveyor belt.
Cause Corrective action
Overloaded conveyor Remove products from conveyor
and test run.
Check the free running of the con-
veyor belt.
Check actual conveyor load
against recommended loading.
Ambient temperature too high Check against recommended
temperature for conveyor.
Chemicals in the environment are
affecting plastic parts Check in FlexLink main catalogue
(section TR) for listing of incom-
patible chemicals.
Damage due to ingress of con-
taminate Clean the system.
Particles, swarf etc. Remove source of contamination.