FlexLink X45 (43 мм) Тех. обслуживание - Manual (Page 4)

4 Maintenance
Maintenance
System maintenance
Introduction
The following section is designed to offer assistance for
your planned maintenance schedule. It may become evi-
dent that the suggested maintenance intervals can be
extended to accommodate your local environmental con-
ditions.
Maintenance of the FlexLink conveyor systems
should only be carried out by competent persons, who
are familiar with FlexLink equipment. If there is any doubt
as to the most suitable procedure for maintenance, con-
sult your FlexLink supplier.
Non FlexLink equipment
Equipment and components which are not from the Flex-
Link family of products should be maintained and serv-
iced in accordance with their respective manufacturer’s
instructions.
Safety considerations
Before starting any maintenance on your FlexLink equip-
ment, the following safety instructions must be observed:
• All electricity must be switched off.
• Make sure that the motor switch is also switched off
and locked in the “off” position.
• Pneumatic and/or hydraulic power must be discon-
nected and any pressure accumulation released.
• Products being transported should, if possible, be
removed from the conveyor chain.
• Staff affected must be informed that maintenance
work is being undertaken.
Warning
Do not climb onto the equipment.
Maintenance instructions
Introduction
This maintenance manual contains directions for the
standard components sold through the FlexLink main
catalogue, for conveyor systems XS, XL, XM, XH, XK,
and XB unless otherwise stated. For non-FlexLink com-
ponents, such as motors, pneumatic equipment, control
systems etc., the manufacturer’s maintenance instruc-
tions apply. In general, maintenance instructions are not
given for equipment which the customer has chosen and
specified for fitting to the installation.
The instructions supplied should be followed to
ensure that the installation runs with a high degree of
safety and to minimize the risk of breakdowns which can
adversely affect the production.
The installation must be used for the transport of
goods in accordance with system specification or within
design criteria as outlined in the general catalogue. If a
fault occurs on the installation which cannot be rectified
with the help of the instructions in the manual, or if unex-
pected conditions occur during servicing, contact your
FlexLink retailer or FlexLink maintenance personnel.
Warranty/guarantee
FlexLink conveyors are covered by warranty/guarantees
as identified within the trading terms issued for each
country. Check the warranty conditions for your system
before submitting claims etc. If you are in any doubt as to
what warranty is applicable to your system, consult your
supplying agent or FlexLink Systems direct.
Spare/replacement parts
If there is a demand for spare parts, contact FlexLink
Systems or your supplying agent.
Checklist/maintenance schedule
A suggested maintenance schedule is shown on
page 18.
Important
Consult your system documentation for any special
maintenance required for your specific installation.