eLine Technology ANPTZ-70-10DN - Manual (Page 37)

31
Using the OSD Menu
En
gl
is
h
• ###: Action number.
• DWELL: Dwell time in mm:ss between 1 sec.~4 min.
• OPT: Preset speed (2~360) when preset is selected. Or, number of
repetitions (1~255) when Pattern or Swing is selected.
6. Press [Near] to confirm each function and repeat step 5 to configure
up to 20 functions.
7. Press [Far] when finished editing the group functions.
8. Select SAVE and press [Near] to save the group or [Far] to discard.
5.4 SYSTEM INITIALIZE
The System Initialize menu allows you to reset settings to factory
defaults or reboot the camera.
• CLEAR ALL DATA: Resets all configuration data, including display,
camera, and motion setup.
• CLEAR DISPLAY SET: Resets Display settings.
• CLEAR CAMERA SET: Resets Camera settings.
• CLEAR MOTION SET: Resets Motion settings.
• CLEAR EDIT DATA: Deletes all Preset, Swing, Pattern, and Group data.
• REBOOT CAMERA: Reboots camera module.
• REBOOT SYSTEM: Reboots speed dome camera.
32
Using the OSD Menu
To initialize one of the options:
• Select the desired option using [Up/Down] and then press [Near]. Use
[Up/Down] to select YES and then press [Near] again. Wait for the
operation to complete.
5.5 RESERVED KEYBOARD SHORTCUTS
Some preset numbers are reserved for direct access to specific
functions in OSD menu.
Function:
• [95] + [Preset]: Open main menu.
• [131~134] + [Preset]: Runs Pattern Function 1 ~ 4.
• [141~148] + [Preset]: Runs Swing Function 1 ~ 8.
• [151~158] + [Preset]: Runs Group Function 1 ~ 8.
• [170] + [Preset]: Sets Camera BLC Mode to OFF.
• [171] + [Preset]: Sets Camera BLC Mode to ON.
• [174] + [Preset]: Sets Camera Focus Mode to AUTO.
• [175] + [Preset]: Sets Camera Focus Mode to MANUAL.
• [176] + [Preset]: Sets Camera Focus Mode to SEMI-AUTO.
• [177] + [Preset]: Sets Camera Day & Night Mode to AUTO.
• [178] + [Preset]: Sets Day & Night Mode to NIGHT.
• [179] + [Preset]: Sets Day & Night Mode to DAY.
• [190] + [Preset]: Sets OSD Display Mode to AUTO.
• [191] + [Preset]: Sets OSD Display Mode to OFF.
• [192] + [Preset]: Setting OSD Display Mode to ON.
eLineTechnology.com