eLine Technology ANPTZ-70-10DN - Manual (Page 30)

25
Using the OSD Menu
En
gl
is
h
• ALARM TYPE [Normal OPEN(N.O) / Normal CLOSE](N.C)]: Sets
sensor input type.
• ALARM ACTION [NOT USED/HOME/PRESET/GROUP/PATTERN]: You
can assign an action for each Alarm input (Preset, Swing, Pattern and
Group).
5.3.3 PRESET SETUP
A maximum 127 of positions can be stored as presets. Preset numbers
can be assigned from 1 to 128.
NOTE: Preset "95" is reserved for starting the main menu.
Presets can be set using keyboard shortcuts or the OSD menu.
To set presets using keyboard shortcuts:
• Press [1~128] then press [Set] for 2 seconds.
To go to presets using keyboard shortcuts:
• Press [1~128] then press [Preset].
To set presets using the OSD menu:
1. Go to the Preset Setup menu (Menu>Dome Camera Setup>Preset
Setup).
2. Configure the following:
• PRESET Number [1~128]: If a selected preset is already defined,
camera moves to pre-defined position and preset characteristics
show on monitor. If a selected preset is not defined, UNDEFINED
shows on monitor.
eLineTechnology.com