eLine Technology EVC Quick Start - Manual

Mounting
1. Unscrew the mounting base from the camera by
twisting the mounting ring counter-clockwise. This
releases all four parts of the dome (base, ring,
hood, and camera). Carefully remove the base
from the other parts.
2. Use the mounting base as a guide to mark the
locations for screw and cable management holes
on the mounting surface. Drill a starter hole at
each marked location. Drill a cable management
hole in the center at least 14mm in diameter to
permit the camera’s cable to be inserted through
the mounting surface. If necessary, insert drywall
anchors into the screw holes.
3. Place the mounting base into location. Insert a
screw through each of the screw holes in the
base and into the mounting surface and then
tighten each screw until the base is secure.
4. Feed the camera’s cable through the access hole;
position the dome onto the mounted base, and
twist the mounting ring clockwise to secure
loosely. This will allow you to adjust the position
of the hood and the camera. After the camera has
been adjusted, tighten the mounting ring securely.
Caution: Once power is supplied, do not remove the
camera from the mounting base due to risk of electrical
shock.
Adjusting the Camera
1. To adjust the camera angle, loosen the mounting
ring just enough to move the camera but not too
much as to make the mount unsecure.
2. After the lens and the hood are into position,
tighten the mounting ring.
Focusing
On models with a varifocal lens, you may adjust the focus
and zoom by turning the screws on the sides of the camera.
1. The screw on the left will adjust the lens focus.
2. The screw on the right will adjust the lens zoom.
3. Focus to the depth of field that is most important.
ELI-EVC
Indoor/Outdoor IR Vandal Dome
User Manuals and Specification Sheets are available at
http://eLineTechnology.com
Caution: Before providing power for the camera, please
read this Quick Start Guide or the User Manual in detail.
Do not attempt to disassemble the camera. If the camera is
not functioning properly, please contact your local
dealer/installer.
eLineTechnology.com