eLine Technology ANPTZ-70-10DN - Manual (Page 31)

25
Using the OSD Menu
En
gl
is
h
• ALARM TYPE [Normal OPEN(N.O) / Normal CLOSE](N.C)]: Sets
sensor input type.
• ALARM ACTION [NOT USED/HOME/PRESET/GROUP/PATTERN]: You
can assign an action for each Alarm input (Preset, Swing, Pattern and
Group).
5.3.3 PRESET SETUP
A maximum 127 of positions can be stored as presets. Preset numbers
can be assigned from 1 to 128.
NOTE: Preset "95" is reserved for starting the main menu.
Presets can be set using keyboard shortcuts or the OSD menu.
To set presets using keyboard shortcuts:
• Press [1~128] then press [Set] for 2 seconds.
To go to presets using keyboard shortcuts:
• Press [1~128] then press [Preset].
To set presets using the OSD menu:
1. Go to the Preset Setup menu (Menu>Dome Camera Setup>Preset
Setup).
2. Configure the following:
• PRESET Number [1~128]: If a selected preset is already defined,
camera moves to pre-defined position and preset characteristics
show on monitor. If a selected preset is not defined, UNDEFINED
shows on monitor.
26
Using the OSD Menu
• EDIT PRESET SCENE: Press [Near] to redefine current Preset scene
position. Then use the joystick to edit the position and press [Near]
to save or [Far] to cancel.
• EDIT PRESET LABEL: Press [Near] to edit Label shown on monitor
when preset runs. Max. 10 characters are allowed. Use [Left/Right/
Up/Down] to move the character selector and press [Near] to enter
a character. Select OK and then press [Near] to confirm Label.
• CAM ADJUST [GLOBAL/LOCAL]: Select GLOBAL to use the WB and
AE settings that are set in this camera for this preset. Select LOCAL
and press [Near] to define custom WB or AE settings for this preset.
eLineTechnology.com