eLine Technology ANPTZ-70-10DN - Manual (Page 34)

29
Using the OSD Menu
En
gl
is
h
To create a Pattern using keyboard controller shortcuts:
• Press [1~4] and press [Pattern] for 2 seconds. Define the pattern
motion and then press [Near] to save or [Far] to cancel.
To run a Pattern using keyboard controller shortcuts:
• Press [1~4] and then press [Pattern].
To create a Pattern using the OSD menu:
1. Go to the Pattern Setup menu (Menu>Dome Camera Setup>Pattern
Setup).
2. Configure the following:
• PATTERN NUMBER [1~4]: Selects Pattern number to edit. If a selected
pattern number is not defined, UNDEFINED is displayed under
selected pattern number.
• CLEAR PATTERN [CANCEL/OK]: Select OK to and then press [Near]
to delete data in current pattern.
• EDIT PATTERN: Press [Near] to start editing pattern. Move the joystick
to the desired start position and press [Near] to save. Move the joystick
to the desired end position and press [Near] to save or [Far] to cancel.
5.3.6 GROUP SETUP
The Group function allows you to create a sequence of Presets, Patterns,
and/or Swings. A maximum of 8 Groups can be stored with up to 20
eLineTechnology.com