Draw-Tite 59855 ROOF RACK - Manual (Page 2)

Remove rails after marking
Hint- it’s not advisable to drill
through the rails.
Note: wear safety glasses during
installation. Drill 1/8” pilot hole and then
1/4” bolt holes.
Apply a generous amount of
silicone into holes before
mounting rails
Position isolator pad, front and rear end
caps on mounting surface and align holes.
Note: open ended rear end caps allow cross
Install bolts and nylon washers into rails and
through the fiberglass mounting surface.
Preparing fiberglass surface for mounting
Installing Track Rails to mounting surface
Blow away any
debris.
Any weight carried on the vehicle will adversely affect its handling particularly in cornering or in a cross wind and the vehicle should
therefore be driven with increased caution. Check the function of all doors and sunroof before driving.
For lost key replacement or other service items call customer service: 1-800-632-3290 or visit:
www.rolaproducts.com
Please have lock core number or part numbers available.
Loads should be evenly distributed and secured.
Page 2 of 2 Printed in China
Note: open ended rear end caps allow cross
bars to slide on and off rails.
Install from under side of mounting surface, the M5 steel washers
and lock nuts. Tighten all bolts securely. Bolts may be covered with
protector caps if desired
Attaching and tightening hardware
ROLA carries a variety of cross bar styles and lengths to attach to our rails. Cross Bars are sold with
mounting hardware.
59855N Rev A 2-11-13