Draw-Tite 59855 ROOF RACK - Manual

PART No.
Carrying Capacity
Tools required to install
K
IT
C
O
M
P
O
N
E
N
T
S
50 kgs
110 lbs
59855
A
B
C
D
E
F
G
H
I
J
Part Description Qty
A Button head bolts M5 x 30mm 12
B Nylon washer 12
C Washer-M5 12
D Hex nut- locking 12
E Screw end protector cap 12
F Hex key- 3mm 1
G Silicone sealant 1
H Track End Cap- open (Rear) 2
I Track End Cap- closed (Front) 2
J Track and Isolator pad 2
A
D
E
Track Rail System
For use on fiberglass caps
Use with ROLA APE and APX cross bar kits
Tools required:
A Masking tape E Drill motor
B Tape measure F Safety glasses
C 8mm wrench G 1/8" Drill bit
D Fine tip marker H 1/4" Drill bit
Placement of Track Rails onto Vehicle surface (truck shell shown)
Page 1 of 2
Align Tracks parallel to each other and equal
distance from rear.
Hint: pre-installing your ROLA cross bars on the
tracks will insure good placement. Using a fine tip marker mark every other hole. Insure to mark the
holes on each end of the tracks.
Hint: Use masking tape to hold the tracks well in place while
marking. Isolator pad can be removed while marking.
Use of ROLA track systems with bolts is intended for
fiberglass top installations.
Install requires drilling and permanent installation of
tracks.
Installation requires some tools and skill. If concerned
please have professionally installed.
Caution- never exceed the load rating for your
vehicle (contact manufacturer for details), or that
of your cross bar system which ever is lower.
Precaution Warnings before beginning
Printed in China
B
C
F
59855N Rev A 2-11-13
G
H
CAUTION
D Fine tip marker H 1/4" Drill bit