beautypg.com

Draw-Tite 24827 SPORTFRAME HITCH User Manual

Installation instructions, Scion tc, Part numbers

background image

Installation Instructions

Scion tC

Part Numbers:

24827, 60213,

77199

Hitch Shown In Proper Position

Wiring Access Location:

Equipment Required:

Wrenches: 17mm, 11/16”

Drill Bits: 3/8”

1

2

If present, remove the tie down brackets from vehicle frame rail. Return bolts and tie down bracket to owner.

1.

Remove the (2) plastic rivets that fasten the fascia tabs to the vehicle. Note: Remove the center of the rivet with a screwdriver.

2.

Enlarge the access holes in the vehicle passenger frame rail only to accept the spacer. See Figure 2.

3.

Feed the pullwire through the newly enlarged hole, attach spacer and bolt and feed one at a time into the frame rail. Leave the

pullwire attached.

4.

Paint any exposed metal

5.

Raise hitch into position, feed pull wires thru adjacent holes in the hitch, remove pull wires and attach conical washers and nut

finger tight only (Be careful not to push fastener back into frame rail). Hand tighten.

6.

Check to assure hitch is centered on vehicle.

7.

Torque all fasteners to specifications.

8.

Reinstall plastic rivets back into bumper fascia.

Rev. A

10-2-08

24827N

Sheet 1 of 3

z

2008 Cequent Towing Products

Pull wire 7/16

Qty. (2)

6

Conical washer 7/16”

Qty. (4)

3

Hex bolt M10 X 1.25 X 30 CL8.8

Qty. (2)

5

Spacer

Qty. (2)

2

Hex nut 7/16-14

Qty. (2)

4

Carriage bolt 7/16-14 X 1.75 GR5

Qty. (2)

1

Tighten all M10 CL 8.8 fasteners with torque wrench to 59 Lb.-Ft. (80 N*M)
Tighten all 7/16-14 GR5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

2000 LB (908 Kg) Max Gross Trailer Weight

200 LB (90.8 Kg) Max Tongue Weight

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Drawbar must be used in
the Rise position only.

Drawbar Kit:

3593

Fastener Kit: 24827F

3

4

3

5

Existing weldnuts

Enlarge Hole

Passenger side only

Frame Rail

Kink Pull wire to keep
spacer independent of
bolt

Frame Rail

Fascia

3/8” dia. Drilled holes

Access hole modification to allow
Pull wire of block and carriage bolt

Existing 3/4”
Diameter hole
in frame

Passenger side only

6

Figure 1.

Figure 2.

1.00 [25.40mm]

.50 [12.70mm]

Form F206 Rev A 5605