Draw-Tite 24760 SPORTFRAME HITCH - Manual

Installation Instructions
Hyundai Accent 4 door Models
Kia Rio 4 door Models
Part Numbers:
60819
24760
77136
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 19mm Socket
Drill Bits: N/A
1. Bolt hitch to vehicle with fasteners supplied in fastener kit as shown.
2. Hand tighten all supplied hardware
3. Tighten all M12 CL 8.8 hardware with torque wrench to 76 Lb-FT. (103 N*M)
Rev. C 8-18-06 24760N Sheet 1 of 3 z 2005, 2006 Cequent Towing Products
Lock Washer Qty. (4) 2
Flat Washer Qty. (4) 3 Hex bolt M12 Qty. (4) 1
Tighten all M12 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 24760F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Wiring Access Location: PC3, PC4
FASCIA
Drawbar Kit:
3590
Drawbar must be used in the
RISE position only
Existing weld nuts
Frame
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
12
3
Note: Fasteners typical both sides
Form: F205 Rev A 5-6-05