Draw-Tite 24910 SPORTFRAME HITCH - Manual

Wiring Access Location: PC 3, 4
j
k
l
m
n
o p
m
n
j
k l
FRAME
o p
FRAME
EXTENSION
m
ACCESS
HOLE
FORWARD
ATTACHMENT
HOLE
Installation Instructions
Ford Fiesta Sedan
Part Numbers:
60342
24910
77297
Hitch Shown In Proper Position
Equipment Required: Fishwire (provided)
Wrenches: 5/8”, 11/16”
Drill Bits: none
1. Place the U-bolts in rear most indentation in frame extension as shown.
2. Raise hitch into place and loosely install the conical washers and 7/16-20 (fine thread) nuts.
3. Using the fishwire (provided) insert coiled end thru forward attachment hole in hitch, into the frame, and out the access hole. Slide
block on and thread carriage bolt into the coil of the fishwire. Keep block and bolt separate until inside frame (see photo above).
Pull carriage bolt and block into position with the thread showing below hitch side bracket. Install lock washer and 7/16-14
(course thread) nut.
4. Tighten all fasteners to the required torque specifications.
© 2013 Cequent Performance Products – Printed in Mexico
Sheet 1 of 3 24910N 10/21/13 Rev. A
j
Qty. (2) U-BOLT 7/16-20
n
Qty. (2) BLOCKS – 3/16 X 1 X 2
k
Qty. (4) CONICAL WASHER – 7/16 o
Qty. (2) LOCK WASHER – 7/16
l
Qty. (4) NUT – 7/16-20 p
Qty. (2) NUT – 7/16-14
m
Qty. (2) CARRIAGE BOLT 7/16-14 X 1-1/2
q
Qty. (1) Fishwire
Tighten all 7/16 fasteners with torque wrench to 50 Lb.-Ft. (68 n*m)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
2000LB (908Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
3598
Fastener Kit: 24910F
Form F206 Rev A 5605
PASSENGER SIDE FRAME RAIL SHOWN
FORWARD
n
FASCIA
Accessory Rating A