Draw-Tite 36417 FRAME HITCH - Manual

Installation Instructions
Honda Odyssey
Part Numbers:
06398
36417
90153
Hitch Shown In Proper Position Wiring Access Location: SUV3
Equipment Required:
Wrenches: 18mm
Drill Bits: None
1. Lower vehicle exhaust.
2. Raise hitch into position
3. Install fasteners as shown in Figure 1.
4. Re-install vehicle exhaust.
Rev. A 5-1-06 36417N Sheet 1 of 3 z 2006 Cequent Towing Products
Conical Toothed Washer Qty. (4) 2 M12 X 1.25 X 35mm CL8.8 Bolt Qty. (4) 1
Tighten all M12 CL8.8 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
3500 lb, 1589 kg Max Gross Trailer Weight
300 lb, 136 kg Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
Rise position only.
Fastener Kit: 36417F
Fasteners Typical Both Sides
Frame Rail
Existing Weldnuts
Frame Rail
Drawbar Kit:
36071
Fascia
Hitch Requires 1/2” Pin and Clip.
FIGURE 1