Draw-Tite 75730 MAX-FRAME RECEIVER - Manual

Installation Instructions
Toyota Hilux
Part Numbers:
75730
Hitch Shown In Proper Position
Equipment Required: Pull wire (provided)
Wrenches: 7/8” & 18mm
Existing weldnuts
Bumper
1. Remove the bolts that hold the bumper in place, being careful not to drop the bumper.
2. Lower the bumper and remove the bumper support bolts and bracket from the frame rail. Return brackets to owner to reinstall if
hitch is removed. Fasteners to be re-installed .
3. Raise hitch into place and re-install bolts (removed in step 2) into the weldnuts located on the frame, where the bumper support
brackets were removed.
4. Using the pullwire insert the spacers and carriage bolts into the frame and into the holes in the bottom of the frame as shown.
5. Remove pull wires and install conical washer and hex nuts as shown.
6. Re-install the bumper at the rearward slots on the bracket using the remaining bolts removed in step 1.
7. Torque all fasteners to specification.
©
2011 Cequent Performance Products Sheet 1 of 3 75730N 9-9-11 Rev. A

Qty. (4) Carriage Bolts 1/2-13 X 2.00 Gr5

Qty. (4) Conical washer ½”

Qty. (4) Spacers ¼ X 1.50 X 2.00

Qty. (4) Hex Nut 1/2-13
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75730F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Wiring Access Location: PU3 & PU4
Form: F205 Rev A 5-6-05
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 9,000 (4086 Kg) 900 (409 Kg)
Weight Carrying
Ball Mount
6,000 (2724 Kg) 900 (409 Kg)
Note: Fasteners typical
both sides
Frame
Existing bolts
Both sides
 

Existing hole
Kink pull wire to keep block
independent of bolt
Example of pull wire procedure
Frame
Bumper

Tighten all 1/2” fasteners with torque wrench to 75 Lb.-Ft. (102 n*m)
Tighten all existing M12 fasteners with torque wrench to 75 Lb.-Ft. (102 n*m)