Draw-Tite 75471 MAX-FRAME RECEIVER User Manual
Installation instructions, Hyundai santa fe, Part numbers

Installation Instructions
Hyundai Santa Fe
Part Numbers:
44549
75471
87414
Fascia
75221 UHAUL
Hitch Shown In Proper Position
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing
Not For Use With Spring Bars
Weight Carrying
Ball Mount
3500 (1589 Kg)
525 (238 Kg)
75221 UHAUL
Equipment Required:
Wrenches: 16mm
Drill Bits: None
Fastener Kit: 75471F
Wiring Access Location: SUV3, SUV4
Frame Rail
Exhaust
Existing
Existing
weldnuts
1
Qty. (4)
M10 X 1.25 X 30mm CL10.9
3
Qty. (4)
3/16 X 1.00 X 2.00 Block
2
Qty. (4)
7/16 Lockwasher
1.
Raise hitch into position.
2.
Install M10 X 1.25 bolts 7/16 lockwasher and 3/16 X 1.00 X 2.00 Blocks into existing weldnuts inside vehicle frame rails.
Tighten all M10 X 1.25 CL10.9 fasteners with torque wrench to 59 Lb.-Ft. (80 N*M)
z
2006, 2007, 2008. 2011 Cequent Performance Products
Sheet 1 of 3
75471N
5-1-11
Rev. E
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.