CEMB USA C68SE (B) - Manual (Page 28)

I 0201 GB - 28
7.6.6.1 - TO CHECK THE ENCODER
When the spindle is rotated:
- the angular position “POS” should vary from 0 to 128;
- the wording “UP” should appear when rotated clockwise and “DOWN” when rotated in the opposite
direction.
Encoder check
Check for correct
operation of the dis-
tance gauge;
the number
increases when the
gauge is pulled out.
Check for correct oper-
ation of the diameter
gauge; the number
increases when the
gauge is rotated out-
wards
Check of the width sonar:
the number decreases
when a surface is
approached to the sonar
Check of the eccentricity sonar (option):
the number decreases when a surface is
approached to the sonar
In the event of failure or faulty operation of the wheel balancing machine, notify the Technical Service
of all the parameters displayed.
7.7 - SETUP NAMES
The machine can be customized by presetting:
a) The name appearing on the Initial screen (screen-save).
b) The name of 4 different machine users ( USER NAME).
An “ideal” keyboard appears on the monitor with the set of characters available for composition of the
wordings.
The Customer’s name consists of three lines, each max. 30 characters.
The USER NAME consists of a wording max. 15 characters.
Special Functions
Width measurement
Adhesive Weight Dispenser
Calibrations
Names setup
Eccentricity Measurement
Drawer unit
Cancel