CEMB USA C68SE (B) - Manual (Page 20)

piano d’appoggio
I 0201 GB - 20
STANDARD Balancing of steel or light alloy rims with application of
clip-on weights on the rim edges
STATIC The STATIC mode is necessary for motorcycle wheels or
when it is not possible to place the counterweights on
both sides of the rim.
ALU - 1 Balancing of light alloy rims with application of adhesive
weights on the rim shoulders.
ALU - 2 Balancing of alloy rims with hidden application of the
adhesive weight on the outside. The position of the out
side weight is on the adapter surface.
ALU - 3 Combined application: clip-on weight inside and hidden
adhesive weight on the outside (Mercedes). Outside
weight position is the same as ALU-2.
ALU - 4 Combined application: clip-on weight the outside and
hidden adhesive weight inside
CTS Special balancing with snap-in adhesive weights
between the edge of the tyre and rim, for both sides.
5.5.5 - TO CANCEL STATIC UNBALANCE
This function can be selected from the Setup screen. It serves for optimizing the residual unbalance by
correcting a wheel with standard counterweights in steps of 5 grams (1/4 oz.).
Thanks to this particular function, the position and best correction value are calculated in order to cancel
the static unbalance: the main cause of the vibrations which can be felt inside the car.
5.6 - STATISTICS
DAILY N° OF RUNS:
Indicates the number of runs performed as from switching on the machine. Such parameter is automati-
cally reset after switching the machine off.
TOTAL N° OF RUNS:
Indicates the number of runs performed as from the last resetting of such counter. This parameter remains
memorized also when the machine is switched off.
The following push buttons are enabled:
6 : serves for resetting the daily number of
runs
7 : serves for resetting the total number of
runs.
Requires correct setting of a password.
STOP : for returning to previous screen (MENU)
MENU' : for returning to Measurement screen
Support surface