Neff K3990X7 - Manual (Page 38)

38
Refrigerator compartment door is
deeper:
If the previous steps for aligning
the door are not adequate:
S Remove the base panel.
S Loosen 3 hinge screws. Do not
completely unscrew the screws!
S Place the wrench on the adjusting
screw.
- To raise a door:
Rotate the wrench clockwise.
- To lower a door:
Rotate the wrench
antiĆclockwise.
Note:
Due to the weight of the appliance
and the food load in the door, the
refrigerator compartment door may
incline, even if the appliance itself is
level. The door gap is not the same
at the top and bottom.
S Remove cap from the upper hinge
of the refrigerator compartment door.
S Loosen hinge screws. If required,
use a socket wrench (A/F 10). Do not
completely unscrew the screw!
S Adjust the inclination of the
refrigerator compartment door.
S Tighten the hinge screws.
S Insert the cap.
Switching on the
appliance
Switch on the appliance according
to the enclosed operating instructions.
Disconnecting the
appliance
Disconnect the appliance according
to the enclosed operating instructions.
If the appliance is to be disconnected
or stored at temperatures below
freezing point, empty the water tank
for the drinking water dispenser.
Emptying the water tank
in the appliance
S Pull out the mains plug.
S Cut off the water supply to the
appliance.
S Remove the motor compartment
cover from the rear of the appliance.
S Unscrew the connecting cable (1).
S Place a shallow waterĆcollecting tray
(capacity approx. 3 litres) under the
connection valve.
S Unscrew, drain and screw back hose
(2) and then hose (3) on the appliance
connection valve.
Important: Do not mix up the hose
connections!
S After draining the water tank,
reĆattach the motor compartment
cover.
Switch on the appliance and then
turn on the tap.
en