Neff K3990X7 - Manual (Page 35)

35
Installation
instructions
Important note:
These installation instructions refer
to various models.
Not all steps are required for some
models.
The appliance may be installed
and connected only by an
authorised technician according
to these installation instructions.
Always connect the water before
the power.
Apart from statutory national
regulations, you should stick to
the connection terms relating to
the local electricity and water
companies.
Keep the installation instructions
in a safe place.
Installation location
Warning:
The appliance is very heavy, for empty
weight see the following table.
Basic model 104 kg
Model with dispenser 113 kg
Model with home bar 115 kg
Install the appliance in a dry, well ventiĆ
lated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e.g.
a cooker, radiator, etc. If installation
next to a heat source is unavoidable,
use a suitable insulating plate or
observe the following minimum
distances to a heat source:
- 3 cm to an electric cooker.
- 30 cm to an oil or solidĆfuel cooker.
The floor on which the appliance is to
be installed must be rigid. If required,
reinforce the floor (appliance is very
heavy, unloaded approx. 145 kg,
loaded up to 400 kg). To ensure that
the ice maker functions correctly, the
appliance must be upright. To ensure
that the doors can open all the way,
observe lateral minimum distances
when installing the appliance in
a corner or recess (see section
on Appliance and installation
dimensions").
Unpacking the appliance
S Remove packaging material and
adhesive tape. (Adhesive residue on
the housing can be removed with the
adhesive side of the removed tape.
To do this, repeatedly place the
adhesive tape on the adhesive
residue and remove).
S Do not remove the transportation
protection devices from the shelves
and storage compartments until the
appliance has been installed.
S After installing the appliance, remove
the transportation protection devices
from the ice maker. To do this, pull
out the ice maker.
Warning:
Before connecting the appliance to the
power supply, remove all the inner and
outer packaging material.
Appliance and installation dimensions
en