MoTeC M1 Tune User Manual - Manual (Page 49)

User Manual
USING M1 TUNE
Printed documents are not controlled Page 48
11.3.3 Setting Channel Display Limits
In addition to other settings, the Channel Properties window also controls channel limits.
Warning limits created for a channel are consistent across the whole application.
Note: These channel display limits are in addition to the high and low parameter limits
displayed in the Error Status list, see
ERROR MANAGEMENT AND STATUS LIST .
Oil pressure example
If an oil pressure sensor is setup with a low limit of 100kPa, as shown here...
...then in any location within M1 Tune where the oil pressure is shown, the value displays in red rather
than in the default color. This is shown below in the oil pressure Bar Graph (for Bar Graphs the bar itself is
red rather than the number) and in the Channel List.